The water bill arrives and the consumption is higher than normal. In looking at the bill you realize it's winter time, your water consumption is down, but the bill says it is up as if its summer when your water consumption is higher. Then it hits you bathtub repair a water leak! At some point almost all homeowners run into this problem.
To find a plumber, all one has to do is flip and run through the Yellow Pages or do a search on the Internet. From there you will see loads of plumber whom are advertising to get your job. The next thing you should do as a consumer is to take remember that there some plumbers whom advertise 2 different ads in the same place. Thus it is important to not water line repair make a rush decision. Look through the list of plumbers available and call a few (minimum of 3).
After you have the stems out you should be able to find the washer on the "inside" end. If it is nicked, torn or brittle it is likely the cause of your drip. Even if it looks brand new, go ahead and replace it. You've already come this far. You can get replacement washers at almost any hardware store. Sometimes you may want to replace the whole stem, especially if the handle end is stripped out. It's best to just take the stem with you to the store and see if you can match it up. Most Do It Yourself stores have replacement stems for many popular brands. If your valve has a center diverter valve to switch the waterfrom the tub spout to the shower head the same process applies. Many times it is easier to replace the diverter stem than to repair it. This really depends on the design of the stem.
Getting advice from someone who has not made any money online is like asking a plumber to shoe a horse when they have never done so. Why in the world would you do this?
If you do not have hot water in your home, it may be a bit tricky for you to attempt to find out what the cause is yourself. If you have a tank that is leaking, this may be the reason why you do not have any hot water. If you have an electrical unit, the causes may be things such as a bad heating element, fuses that are blown, an overload switch which is bad, circuit breakers not working properly or faulty thermostats. If you have a gas tank, the problems causing you to not have hot water line repair may include a problem with the thermocouple burners. In situations like these, it is imperative that you contact a reputable plumbing company to get everything squared away.
And the way to know what's sufficient? Well, until the work is done an the bill paid you won't know for certain, but this is the best that can be suggested and normally works very well.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.